6 speed manual transmission 97 f350

Blog - 1980-1997 Ford F-250+ - Diesel Conversion Specialists

Ok guys looking for as much info as possible about swapping a 5 or 6 speed manual trans in a 97-03 5.4 F150. I have installed the Baumann Re Cal pro on level 3 and I think I have broken a 1-2 accumulator spring for the second time and I don't want to spend anymore money on the darn slush box. You can still use your existing PCM, just have the tranny control turned off.

L Power Stroke Diesel Specs & Info - Powerstroke Hub

I have been following the 5.4 swap into the mustangs and it seems straht forward for them. So a 2000 F150 5speed 4.6 computer or a 2000 4.6 Mustang computer should work? I have never looked under the carpet in these trucks but do the tunnels already have the knockout for the shifter? from a v6 or 4.6 manual boneyard truck should bolt rht up as well.

Ford ZF 5 <b>speed</b> <b>transmission</b> parts F250 <b>F350</b>

Ford ZF 5 speed transmission parts F250 F350

I am mainly concerned about computer tuning, flywheel, and clutch master cylinder/clutch pedal travel. You will need to cut the floor as there is no knock out but the impression is there. You will need to cut the hole in the firewall for the clutch master cylinder. I just need to borrow a vehicle to drive and get this underway.

Ford F350 Parts -

Thanks Blake The crankshaft from your 5.4 uses an 8 bolt pattern. Now something else, I have the predator on my truck rht now.Manual Transmission Fluid Chart - FCSD Chemicals and Lubricants


6 speed manual transmission 97 f350:

Rating: 88 / 100

Overall: 98 Rates